pjdoney (not verified)

I did take the pH before and after the other two previous cooking times.  They were about 4.6 at the beginning and end of processing.

So, you want me to make a third new dyebath using distilled water.  I used fresh dyebath this morning after throwing out the orignal batch.  I don't have the sodium hexametaphosphate but can order some in.  I will test the pH of the dye bath after adding Glaubers (test), sodium acetate (test), and A. Set (test).  I should also test the pH of the dyebath before I put the wool skein in.

Did I miss anything?

pjdoney (not verified)

5L distilled water 5.0 pH

1/4 tsp/ 2.5L A. Set  4.9 or 4.8 pH

1/4 tsp sodium acetate/ 5L  5.3? pH

2 gr/ L Glauber salt  5.6 or 5.7? pH

12 mL 5% acetic acid  4.5 pH

I measured the pH of these in the order written.  Some of the pH colors were very hard to tell so I have indicated my uncertainty (gotta find my digital pH meter!).

Here is a link to our utility company's report on our water:

http://www.csu.org/residential/services/water/wqr/item6292.pdf

Approximately 75% of our water comes from mountain streams.  "The majority of this raw water is transferred to our city through pipelines that help to protect it from contamination, such as herbicides, pesticides, heavy metals, and other chemicals."

In addition to this water, we also use local surface and ground water sources (slopes of Pikes Peak, creeks, watershed, wells on three different aquifers) and treated surface water that is routed through a river.

Here is a link to the Detected Contaminant Table:

http://www.csu.org/residential/services/water/wqr/item6298.pdf

Copper is listed at 1.3 ppm and lead is 0 ppb.

As far as I know, we have soft water.

Now, your previous comment that:

"Sometimes the addtion of the wool or dye changes the pH and that is a problem if the pH has already risen to 5.0 before you start heating, that would cause less exhaust."   - I should put my wool in the 300 mL dye bath and check the pH right away and let it sit for 10 minutes.  Take the skein out, add 2.25 mL of Olive dyestock, put skein back in, and measure the pH again, and let skein sit for 10 minutes.  If it is up to pH 5, should I add small amounts of acetic acid to the 300mL dyebath/ plus dye?

 

Thanks, Karren, for your help.  I haven't pulled any of my hair out...yet...

pjdoney (not verified)

Thanks for clarifying when to check the pH from what I had written to you.

I have the calibration fluids - I've just mis-placed one of them with everything that is crammed into the room.  I'm being a pain by not wanting to re-order but at the rate I'm going through pH test strips, I'd probably save money in the long run.

I can certainly scour the wool.  I will try it first the way that I have been doing it with the class.  If I am still having issues, I'll scour the yarn and give a report back with the distilled water dye bath.

Do you have any thoughts as to why some of the colors in the Olive Green exhaust but not the red gold? 

pjdoney (not verified)

I'm still in cool-down mode and haven't measured the pH yet but the water temp is close to 120 F and it looks like the same old color in the bottom of the jar.

Karren, do you have a preferred method for scouring wool yarn?

pjdoney (not verified)

I am going to try and dye the normal way tomorrow using my distilled water dye bath with unscoured wool yarn.  Jeff found my missing buffers for the digital pH meter and it does not agree with my strip stick color readings!  My tap water with the digital meter was 6.9.  I think I remember the pH strip showing a reading of 5.3.  I have had a greenish cast to all my result colors and found it very difficult at times to try and determine a reading.  I sure felt dumb knowing that I was in a class learning how to disect colors and struggling with pH! 

By the way, the pH when I finished the distilled water dye bath earlier was 5.0 but I don't believe it now.  Hopefully I can dye tomorrow afternoon after church and have something positive to report back on tomorrow night!  Hope is kindled....

pjdoney (not verified)

We did a two point calibration last night of 7 and 4.  Then we tested our water.

I'll try and write more later about the yarn, etc.

pjdoney (not verified)

It'll probably be tomorrow morning before I know if the dye job worked.  We ate lunch after church and received a phone call from our youngest.  It appears that she caught whooping cough (pertussis) from the kids at her work.  She needed groceries and medication so that took up time.  The dwell time will be done in a few more minutes and then the cool down. 

Looking forward to seeing the results.

Mary Rios (not verified)

i don't get where we are suppose to get these chips? do they come from our packages?

thanks!

DebbieB (not verified)

Just think of the nice wide blankets! Alas, I'm a shortie. That's wider than my wingspan!