I recently purchased a floor model Mountain Loom with 16 treadles and 8 shafts.  This company is no longer in business and cannot give me any information about  its workings.   My question is "must I keep all treadles tied up even though they are not being used"? It seems that it would be easier to treadle if on an 8 shaft pattern  I could unhook the remaining 8.  I also have a glimakra countermarche loom which I only tie up the treadles that I need which makes treadling very easy.  Help, please.

Comments

suem

If this is a jack loom,  just tie up the treadles that you need.  With so many treadles, you can even skip treadles so that your feet have more room to move around:)

 

Sherrienanneal

Thanks Suem for your response. I failed to indicate in my description that this loom is a parallel countermarche with a vertical tie up (very similar to a Louet loom).  Both sets of lams span the entire width of the loom and the treadles cannot be removed.  Do you still think your suggestion to tie up just the treadles needed will work?

Sherrie

suem

Sorry to take so long getting back to you.  Some countermarche looms are easier to balance when each treadle is tied up to some shafts.  Try only tieing up the ones you actually need and see how the loom works.  You may need to tie up some (or all) of the other treadles to at least one shaft for it to balance properly.  Joanne Hall's book (Tieing up the Countermarche Loom) as a lot of good, general information).  Do you have a  instruction manual for the loom? 

Regardless of the manufacturer, and whether it's horizontal or vertical, all countermarche looms work pretty much the same way.  One set of lamms controls the rising shafts and the other set controls the sinking shafts.  If your loom is similar to a Louet, perhaps the instructions for that loom will be helpful. 

 

 

Submitted by Sherrienanneal on