Hello
I'm a beginner to backstrap weaving so I know the problem is something I am doing. I have a rigid heddle and have single warp. By that I mean it is not continuous. It is tied off at the base stick that i hold to me with the backstrap.
I began my weaving with a few hefty rows of header to try to keep my warp separate and in place. I couldn't seem to get the twining to work no matter what I did, even though I have seen others use this method to control and separate warp. My weaving progressed well at the beginning, straight, using the heddle as a beater as it is meant to be and having other tools to beat or separate the warps if i felt it was necessary.
My problem now is that my warp keeps drawing in and I realised today when I had a good look at my weaving that even though it looks nice, its shrinking and I cannot use the heddle as a beater as the weaving from both ends is no longer even with the warp, its drawn and all the warp appears to be tight and shrunken. Its hard to explain but i'm sure experienced weavers know what I mean.
I am going to UNweave everything I've done as I'm just not prepared to accept such an obvious mistake.
Can any of you tell me what I'm doing wrong and how to correct the mistake so I don't do it anymore? I don't have a temple that I've seen others mention and anything I have or use has to be something I make. How do I make sure the weaving remains even all the way along? I'm frustrated with myself but have no intentions of giving up, just keep trying until i get it right.
Thanks all
Sharon
Comments