Hi.  Does anyone have any pictures, or advice on where to position the lamm depressor?

I have an old (1958) Macomber, just ordered a lamm depressor.  I found pictures and instructions on how to install it, they explain about measuring the height.  The part I'm not clear about is where specifically it needs to be installed vertically on the cross piece?

I was looking at the pictures posted on macomberloomsandme.blogspot.com, but I'm not following if it matters where vertically it should be aligned.

Thanks

Susan

Comments

Thu, 09/24/2015 - 01:14

Michael White

Faceing the loom from the front the depresser needs to sit just to the right of were the left side lamms flex (the high point of the lamm). I will post a picture tomorrow. This laptop doesn't have any pictures on it.

 

Michael

Thu, 09/24/2015 - 11:46

Michael White

Here is the picture of the lamm depresser.

Sat, 11/14/2015 - 17:42

sgkatcher

Thanks so much for your help and the picture.   I have the lamm depressor installed and it definitely helps.