I just purchased a used Ideal loom and am enjoying the process of putting it together and getting the first warp on. I have read all the threads in this group and will be using the tips I have gleaned! However, I did not see anything about keeping the back beam from reversing when there is no tension on it. For example, while winding a warp (B2F) I wind, go to the front and pull small bouts of yarn all the way across the warp, then go to the back and insert sticks, then wind some more. When I take the tension off of the warp threads in the front, the back beam "rolls" backwards, loosening the wound warp and the sticks fall out. The looms I'm used to have brakes that don't allow the back beam to go in reverse unless released. I am not sure how I am going to handle this lack of tension on the back beam when I go to thread the heddles. Any tips?

Thanks,
Jennifer

Comments

Sara von Tresckow

 Do you perhaps have the ratchet and pawl mounted backwards?

There should be a ratchet wheel tension on your loom.

jordanj (not verified)

Sara,

Here's a picture of the setup. It actually worked fine during threading, but I could not wind the warp on by myself. I know that others use a S hook and a weight, and I tried that, but the S hook kept slipping, so I must not have had it arranged correctly. Guess I need to do some research! I have a narrow (8") warp threaded and sleyed and will tackle the setting up of the countermarche in the morning. I am missing a few parts, like the pins that hold the beater up and the shaft pins, so I am making a list of things I need to order from Joanne.

 

Sara von Tresckow

 You may have the warp turning backwards on the beam (it should appear to go over the back beam straight down to the warp beam) or you may have put the tension wheel from the front on the back and vice versa which would reverst the way the pawl grips.

Joanne Hall

Hi Jennifer,

Did you turn the wheel clockwise as you wound on?

Joanne

Submitted by Anonymous (not verified) on