I’m a beginning weaver and have a few questions about my next project. Has anybody made the summer and winter placemats from Handwoven’s ebook Top Ten Placemats? I’m a little unsure where to begin reading the profile draft so I can begin threading.

I don't think I'm going to be able to get 258 warps on my warping board. Is this common?

Any tips would be greatly appreciated.

Thanks,

Shelly

Comments

claudia (not verified)

Hi Shelly,

You may want to try winding your warp in 2 or 3 bouts.  If there is a logical separation point, use that or, divide it in half and wind two bouts (sections) of 129 ends each.  Once you finish winding one section, chain is off the warping board and then wind the second section or bout.  It's the easiest way to handle a warp with more ends than you think you board can handle.  Watch you tension and try to keep it as even as possible with both sections.

As for profile drafts, the description in Deb Chandler's book is quite good.  It's basically a representative draft where the blocks are shown on the profile draft and not the threading. You can have 2, 4 or more blocks and the profile shows the blocks.  The threading draft shows the threading of each of the blocks.  Blocks can have anywhere from 2 or more threads and the profile draft shows just the blocks. 

You can have different threadings for the same profile draft.  So, one draft can be used in several different ways.  Here is a profile draft and threading draft below it.  Don't use this threading draft, it is incorrect.  It should have shown the two blocks as Block A= 1,3,2,3  Block B= 1,4,2,4. 

Hope that helps.

Claudia

 

 

snaseman (not verified)

Thanks Claudia. It is very helpful. I have Deb Chandler's book and have read the section a few times. In this particular draft, there are two blocks, a gap, then the rest of the profile. I wasn't sure what to do with the gap.

claudia (not verified)

Wow, a gap.  Now, that's a great question.  I don't have that particular publication so it's hard to say.  I'd have to see it or someone with more experience with profile drafts may come to our rescue. 

Claudia

Submitted by Anonymous (not verified) on