Hi,

I just acquired a Fanny counterbalance. I'm also new to floor loom weaving, although I've used a rigid heddle for some time. After reading the intro to the Handweaver's Pattern Directory, I have a question about the tie-up grid (shaft combination) instructions mentioned on page 9. It says that if you have a foot-controlled loom that depresses the shafts, then read the combinations to be treadled as the empty squares. I'm assuming they mean to do this only if you have a sinking shaft loom, not a counterbalance. For the Fanny, I would still use the black filled in boxes, correct?

Comments

Sara von Tresckow

 This discussion comes up so frequently and is not all that difficult.

If a black square in your book represents a RISING shaft, and a sinking shed represents a SINKING shed, just match your risers and sinkers to the diagram. In the case you mention, tie your sinking shafts to the blank squares and your rising shafts to the filled(black)squares. Period.

The "type" of loom doesn't matter - as long as the risers and sinkers match the diagram.

 

Joanne Hall

It is unfortunate that she wrote those instructions to be the exact opposite of a traditional draft.  But for most of the first weaves in the book, it will not matter since they are reversible.

Joanne

Weavin Steven

 Thanks for the quick replies. I think I'll try it both ways. I prefer to see the pattern on top of the weaving as opposed to below, so I'll probably enjoy doing the tie-up with the rising shafts.

claudia (not verified)

So, it's 4 days later, how did it go?  Did you get a chance to do some weaving?  What do you think? 

Congrats on the Fanny.  Happy weaving,

Claudia

Weavin Steven

Well, I sort of started weaving. The tie-up issue was easily solved. Now I'm trying to find a comfortable bench. I had no idea how important having a good bench is when weaving. 

It appears that the actually weaving part of this craft will be fun. It's the actually getting started and setting up that seems to be a bear. 

Submitted by Weavin Steven on