I was warping the beam, putting on to the loom for the first time, had my lease sticks in and was combing out the warp as I was winding it on to the beam. I had problems at the cross, I keep getting knots in one section and broken treads. As I combed out the treads I had more tangles down the warp and had a hard time combing out the tangles. I know that I lost about a dozen threads that broke, but did get it on the loom. I was beaming back to front with a raddle in place. What did I over look as I was beaming the warp on to the beam to have had so much trouble with knots at the cross and tangles in the warp as I was combing out the warp?

Comments

lkautio (not verified)

It is possible that the section with problems was looser than the other sections, allowing it to tangle more.  Or, if it was a different yarn, it might have had a different elasticity (stretchiness).  Sometimes an almost invisible thread gets caught in the warp and can cause all sorts of problems.

Rather than combing, which can cause tangles, rely more on even warp winding and keeping the warp under tension as you beam.  Allow the lease sticks to move freely. I make a figure 8 of cord on either side of the loom and put the sticks, tied together into the two sides of the 8.  That allows them to move so they are less likely to be an immovable barrier when something gets stuck.  Put your hand into the "shed" caused by the front stick and slide it gently to open the two layers.  You may need to snap or slap the warp if places stick (rather than combing).  Work the sticks as far forward as possible and wind on under tension until the sticks reach the back beam.  Remember to insert paper or sticks on the back beam as you go.  Repeat the clearing and bringing the sticks forward before winding on more. It gets faster and easier each time you do it.  

If you have the space a warping trapeze can speed things up and make it much easier.  I hang a thick pvc pipe from the ceiling over the back beam, throw the warp over it, and hold or tie a weight to the warp for tension.  Kati Meek's book, Warp with a Trapeze, Dance with Your Loom or Faithe Nunneley's book, Thrums, have good pictures of the trapeze process.   Becky Ashenden has a short video on her Swedish Vav Stuga site:  http://www.vavstuga.com/resources/mm/  If you look closely you will see her moving the lease sticks back periodically.

Laurie Autio

claudia (not verified)

Although I did not post the question, I want to thank Laurie for her very thorough and helpful response.

I recently read in Peggy Osterkamp's book that you should never comb a warp with your fingers and that tying the lease sticks separately can help prevent  this type of tangling and breakage.  If you run a piece of yarn or string across the length of each lease stick, they will maintain the cross separately and allow the yarn to run through the cross more easily.  It's hard to explain.  Peggy has lots of helpful tips on her website:  www.weaving.cc/leasesticks/previous_tips.html  Even though I own all three books, she has a few items in the tips section that are not explained in the books. 

As Laurie also suggests, good, firm tension and sometimes slapping the warp work much better.  I recently purchased Kati Meek's book but am waiting for my new-to-me Glimakra Standard before I rig up a trapeze.  I doubt I'll need one with that loom.

Claudia

Submitted by Anonymous (not verified) on