One person expressed concern about my 'scary' painted warps in the Projects section so I did a photo essay showing how I beam one using a warping valet.

http://laurafry.com

Once there click on Education, then on Articles

Cheers,

Laura

Comments

TinaHilton (not verified)

I'm getting caught up on my forum posts here.  My husband built a warping trapeze for me to use with my LeClerc Mira.  That loom is gone and I need a wider board/rod for my AVL since it's a wider loom.  But even with that, I can't quite figure out how to set the legs against the loom.  I'm thinking more and more about trying to hook it to the ceiling like yours Laura.

I mostly warp sectionally on this loom, but plan to do some warp painting this summer so I'd like to use the valet for that.  And I want to take the time to try using a reed in place of the raddle.

Thanks so much for all the photos.  It's much clearer than just words, so I appreciate you taking the time to share them.

kerstinfroberg

Not knowing how your valet looks, this suggestion may be unuseable... but: couldn't you just put it inside the sectional track "beam"? Of course this means that you go directly from the valet to the warp beam, with no "secure" place to put the reed. I usually just tie the reed somewhere - on the track, for instance.
Or, if you want to do it from the front - cover the sandpaper beam, stand the trapeze inside it, route the warp from the back apron - over the roller - through the shafts - reed in beater - under sandpaper beam - up and over the valet's cross piece. Would that work?

My warping valet is not constructed - I have two tall 2by2 with a hole at the top, and a piece of tubing. When I'm using it, I just place the wood pieces inside the loom, put a long pin through the hole into the tube. (Incidentally, the pins are for tying up treadles, and the tube was originally bought to reinforce the knee beam.)

laurafry

Hi Tina,

There are more pictures on my website - click on Warping Valet.  Those photos show how I do it on the AVL.

Cheers,

Laura

TinaHilton (not verified)

My warping valet was made using the design in Kati Meek's book.  I'll have to try figuring out where to place the legs of the valet.  But first I still need a longer piece of wood for on top.  It was sized for the 45" Mira.
 
Laura - is the "very tight choke tie" added by you before beaming?  I assume so, since I haven't seen a tight choke tie on a painted warp because that would prevent dye from going through.  I've always been nervous about removing the tie on the end loops and "losing" the end spot and affecting the color placement.  That's the main thing that makes me nervous about rough sleying through a reed with a painted warp.

laurafry

Hi Tina,

I wind the warps and put a very tight choke tie on the warp close to the cross so that the resist marks are in the loom waste.

Cheers,

Laura

TinaHilton (not verified)

I didn't think about that being part of the loom waste Laura.  I've only done two painted warps.  The next one will be better with these tips.

villageweaver (not verified)

I just replaced the top horizontal for the same reason. I went to home depot and bought a 7 foot long oak board. Mine was 3/4 inch because that's the size in the verticals that hold it. Then i took it to my local cabinet maker and asked him to round the top sides so the the thread would run a bit easier over the wood.

Submitted by laurafry on