I f you don't have a warping board you can clamp some stakes to a table and use those as warping pegs. They will need to be very firmly clamped so don't clamp them to a good table. In this photo they are clamped HARD to a board.
Some people drive stakes into the ground in their garden or use the pegs on their inkle looms. What ever way you choose, make sure your stakes are FIRMLY grounded. THEY MUST NOT BE ABLE TO MOVE AT ALL !!. As you wind your warp, loose stakes will start to lean in towards each other and this will create uneven tension across your warp.
.jpg)
1. Tie your warp to the first stake with a big loop so that it easy to slip off when you finish and slip on to your loom bar.
2. Wind the yarn in a figure-of-eight creating a cross in the middle.
3. Cut and tie on yarn at the starting stake. Finish at stake A again tying around the stake with a big loop.
I have photos and video on basic warping on my Flikr page here.............
www.flickr.com/photos/39560980@N05/sets/72157620403266756/
Laverne
Comments