Hello ;) I've had my very patient Dorothy Tabletop loom out since before Christmas promising soon I would get up the nerve to try again...poor old girl. Technically I "could say" I've been weaving for 20 years. But 5 times in 20 years would be more accurate. I have to learn all over again each time.   I have finally warped it for a narrow scarf using the Learning to Weave book. Below the pattern for Rib Weave (pg. 120) it says "all these are threaded on a straight draw." (4,3,2,1 - 4,3,2,1 - etc.) with first harness 1 lifted, then 2,3,4 together.   PROBLEM(?) It looks like there are 3 warp yarns hanging every other row without a way to make the edge neat?   Should there be a floating warp (I've only read about) on the edges or perhaps this was meant as a lesson in plain weave and not intended as a complete design on it's own?    Considering re-threading atleast the first and last groups of heddles. Indecision & uncertainty continue to threaten my tabletop loom experience for another 20 years!!   Laurie in Maine

Comments

claudia (not verified)

Laurie,

Threading, especially on a table loom, can be tricky. Just when you think it's perfect, you find mistakes. I have a feeling, based on your description, that you have 3 threads that are either threaded incorrectly or they became crossed when coming from the heddles to the reed.  There is a wonderful "Troubleshooting" section in Deborah Chandler's book and I believe she covers what to do. Basically, you need to follow each of those 3 threads and make sure they are threaded in the right order, in the right dent in the reed and that they are tied onto the front apron bar with even tension. That ought to cover it all.  I don't believe, after 5 years and a couple hundred warps, that starting all over will be the best way to go unless you want practice threading  LOL

Claudia

Su Butler

HI Laurie....if you start your threading on shaft 1, then thread 4,3,2,1 and weave by alternating shaft 1 with 2,3,4, every thread at the edges will catch.  There is no need for a floating selvedge.  Many weaving patterns require an extra "balancing thread" to make the patter work well at the selvedges.  If you don't want to rethread, just wind an additional thread and thread it on shaft 1 and weave away.

Su

dognapper2 (not verified)

I had the heddles threaded right and I guess it was just my imagination that the edges would hang outside of the weft shot - except when I moved a lever wrong. I didn't visualize what Rib weave would look like right in my mind.
 
I've enjoyed myself but I have to admit this project has been (another) lesson in what NOT to do, from the yarn I chose and the way I threaded the reed. Every other space was too far apart and I broke a warp 6 inches along. Fixed it though - so there's that practice under my "backstrap" belt!
 
Luckily it is not terribly long and I'm almost out of weft as well. I've promised Dorothy not to put her back in the closet. I WILL try again!
Laurie
Submitted by Anonymous (not verified) on