Finished Length Unit
yards
Finished Width Unit
yards
Length Off Loom Unit
yards
Length on Loom Unit
yards
Notes

See tie up below

set up treadles so that top was on right side with 1,2,3.4 and bottom was left treadles at 5,6,7,8  but order was from right to left. Messed up threading and it did not work. Took 2 weeks to get tie up correct. 

1.5" from right to left 1,5.6,2,3,7,8,4 for hem, same thread for fear of hem getting smaller.     

2.75" blue 2(1,8,7,4,3,6,5,2) ; 2(1,5,6,2,3,7,8,4)  m/w pattern until length completed

1.5" gr, wht, gr(1,5,6,2,3,7,8,4) each color repeat is 0 .5"

20" b,g,w,g @ 1/2 " repeats per color 

51" b.g.w.g @1"repeats extra inch to get pattern repeat correct 

20" b,g,w,g @ 1/2 " repeats per color

1.5" gr, wht, gr(1,5,6,2,3,7,8,4) each color repeat is 0 .5" 

2.75" blue 2(1,8,7,4,3,6,5,2) ; 2(1,5,2,3,7,8,4)  m/w pattern

1.5" from right to left 1,5.6,2,3,7,8,4 for hem, same thread for fear of hem getting smaller. 

 

Had to drop 2" off wound warp because loom was shorter than I thought. Then had to drop 2" off edge because I did n't have a wide enough reed. Kathy says I measured wrong as the reed is long enough

We reworked the loom before I started this project. I  bought new heddle bars  for Christmas. I researched loom issues, Marcy, Kathy, Marcy's hubbie Terry and I worked on loom for several hours. He then took treadles off, cleaned them out so that treadle rods did not stick and more and bind up. All this work resulted in a loom that had clean shed and I did not have problems with threads crossing or clean sheds on this project . Then the bar that holds the treadles to loom started sliding out. Kathy and Terry worked out a solution that involved drilling a hole somewhere in the rod and expanding it with a screw Glad I was not involved in that decision.  

 

Threw shuttle from the right with the fold on the left.

Weighted the fold on the left by placing lease sticks through the loom lengthwise, attached clips to the edge of the fold to hold it wide and reduce draw in. I still had a significant amount of draw in. Some things that seemed to help. pull out extra yarn before throwing the shuttle, get close  to a loop on the edge, make the arc to get the loop to touch the edges. 

Planned final dimensions were 80x90 with 1.5 inch hem. Finished dimensions were 80x89 after hemming and washing in washing machine and drying in the dryer. This yarn had a LOT of lint, came out very soft and I did not use fabric softener. 34' of loom waste - I was running out of warp when I finished but still had  clean shed. I had removed the optional extra 2 shafts so that gave me a few inches. Make sure to account for extra loom waste if using all shafts. 

 

Number of Shafts
8
Number of Treadles
8
Project Status
Finished
Sett Unit
epi
Width off Loom Unit
inches
Width on Loom Unit
inches
Submitted by Frecklefacedfrannie on