Hi, I can't seem to figure out the best way to center the warp. The videos I watch show how to start on one edge of the project and thread the warp to the other end. I always end up with more leftover reed on one side than the other. Should I take the measurement of the project in reed and divide it in half to know where the center will be and count from there to the edge for starting? Or should I take a tape measure to find the center of the project and use the tape to measure out to the edge of the project?
Does this even make sense?? Bottom line: how do I measure accurately to find the starting place for the project?
Thanks in advance for your help-- again! Audrey