Caroline (not verified)

A RH loom has no treadles, but a lifting plan, and this is what you see down the right hand side of the pattern draft. If you look at the top right hand square, it gives you the different combinations of sheds necessary to make the pattern - you have a choice of 2 sheds, and then the rows of squares below that tell you in what sequence you select and manipulate the 2 RHs to get the pattern. 

If you follow the WAL from the beginning, it starts with the threading plan and lifting diagram for a plain twill, then builds up to introduce patterns that get progressively more complicated as your skills build up. The discussions will give you a good idea of bits that weavers have found tricky. The sheds used are talked about and explained, otherwise you can PM CraftinSusan if there is something you do not understand, or is taken for granted and not mentioned.

Good luck with it - its kept everyone very busy!

betzfrederick (not verified)

I have been planning on doing this WAL for a couple of months but life kept getting in the way. Now I am ready to start!!  I am wondering if I should  use two 10 dent heddles with 3/2 ASTRA on my Beka loom.  Does anyone have any advice?  Has anyone tried the WAL with 3/2 ASTRA?  Thanks, Betz

betzfrederick (not verified)

Thanks for your explanation. I didn't look up the wpi.  I used a common yarn sett chart and found the sett for 3/2 cotton is 10-14 epi for tabby and 15-18 epi for twill.  That is why I was thinking two ten dent heddles would work since 150% of the epi would be 15.    I do have two 8s I could use though. 

I have another question.  Could you explain when you would use sett and when you would use wpi?  Are their specific instances when you should use one rather than the other?  I appreciate your help.  Betz

betzfrederick (not verified)

Thanks.  I am going to use two 8 dent heddles as you suggested.  I was planning on making the warp 3ft long and 6 inches wide. Each of the twelve sequences will be five to six inches long so they are square with a pick or two between each sequence.   How does that sound?  How long was your warp?   I appreciate your help.  Betz

betzfrederick (not verified)

I think it was drafts 6 & 7, correct?  Betz

betzfrederick (not verified)

I'm trying to figure out how to thread the heddles.  Which heddle is the front one?  The one with the red thread in the holes or the one with the blue thread in the holes?  Sorry to be asking so many questions.  Thanks for your help.  Betz

claudia (not verified)

Hi Betz,

The first post in this series of comments has the three threads and two heddles in a drawing.  The red line is a thread, the heddles are the 2 sets of holes and the spaces between the holes represent the slots of the heddles.  Here is the explanation for threading the 2 heddles:

So, the red line is thread 1, the blue line is thread 2 and the black line is thread 3.

Hope that helps,

Claudia 

kellytwo (not verified)

The problem samples were #6 and #7. They had floats along the back that never got connected. They just keep floating along. The front heddle is the one with the red thread in the holes. The picture is drawn like if you were sitting at the loom looking at the heddles.

betzfrederick (not verified)

It does help.  Now I'm ready to warp.  Thanks again.  Betz

TNWEAVE (not verified)

One set of numbers represents the number of shafts on the draft and the other set of numbers represents the tie up sequence.