Threshkin (not verified)

How do you securely attach the pins to the shuttle sides?  I have made custom sized shuttle like this before but have had a hard time keeping the pins and sides together.

Thanks!  Erik

TheLoominary (not verified)

Hi Erik, because I don't have a lathe to cut a stop shoulder on the pin, I chose to do it this way: I drilled countersink holes in the sides. I pre drilled the pins with an 1/8" bit so as not to split them. I put a VERY SMALL dab of "Liquid nails" on the ends of the pins, then screwed the pins to the sides with 1" dry wall screws.Then, using wood glue I glued the pegs over the screw heads, cut off the excess, and sanded. A couple of hints, I held the pegs with a rubber tipped Quick Clamp while setting the screws. I also used a butter tub lid with a tight hole in the center over the peg to protect the shuttle sides when trimming the pegs. Hope this helps, Frank.

Threshkin (not verified)

That makes sense.  I just drilled holes in the sides and slid the pins in.  There was not enough surface area between the sides and the pins for the glue to make a good bond.

I might just pull the pegs out, move them a little and try your approach.

Erik

TheLoominary (not verified)

Hi Erik, Sounds like your change will work. Here is a larger photo to show the countersunk holes better. My method is very strong, as it also relies on the mechanical bond of the screws, with just a dab of construction cement to keep the pins from ever turning. Since the sides are only 1/4" thick the countersink is a shallow 1/8".Applying wood glue to the plug sides and letting them set well before cutting was important. You could also use the construction cement "Liquid Nails" to set the plugs, as it will stick well even to the screw heads. Regards, Frank.

Threshkin (not verified)

I will try this after I get the shuttles unpacked.

icecharm (not verified)

I have made belts just using a couple of D-rings from Michaels for the hardware. It works well enough.

weavinfool (not verified)

What is Michael's?  Is that a store?  I hadn't thought of D-rings.  Thanks for mentioning that.

weavinfool (not verified)

Thanks for the link to that thread.  The belts you made are outstanding.  Once I get a little more experience with the inkle loom, I want to learn to do some more advanced pick-up such as the Andean pebble.  At the moment I'm working on the bird motif with the simpler warp pick-up.  I'm using Size 10 crochet thread in order to fit it all onto the inkle.  I'll probably use 5/2 perle cotton for the belt. As for design, quite frankly, you inspire me.

That hardware is what my husband is looking for but having some difficulty finding it.  We'll keep searching or try to think of alternatives.  I'm curious how you did the holes.  You said you sewed to reinforce where you would puncture the weave.  It looks like you also used a type of belt grommet? 

Thank you for making so much available in terms of technique and designs. 

Coolsticks (not verified)

You may want to recycle the metal parts of a belt from the thrift store.