I am puzzled by my 8-shaft Louet Delta loom.  I don't have a lot of experience with it, but it's never done this before.  I tied the treadles for a 4-shaft huck threading (the towels designed by Lynn Tedder in this month's Handwoven).   4 of the treadles function properly, but the other two just stay on the floor when you depress them.  The ones doing this both are tied up on 3 upper lams and 1 lower lam.  When I have the mechanism in neutral position, everything look nice and even.  Can someone please suggest to me what might be going on, and where I should go from here.  Thanks a bunch!

Comments

Ellen (not verified)

Hello Karen.

This may be a little late, perhaps you have already figured it out, but I have been un-connected to the internet for a while.

I can't tell you what is wrong, but have often found it a help to ask somebody else to depress the treadles while you can move around and look from the sides and down under to see where something is wrong. It usually suddenly becomes clear then, that something or other sticks to something or goes the wrong way around something or...

Good luck if you haven't already solved it long ago :-)

Submitted by Anonymous (not verified) on