Comments

Sat, 09/15/2012 - 04:03

francorios (not verified)

Well done!

Have a good day!

Sat, 09/15/2012 - 09:03

ReedGuy

Pretty clever there. :)

If you had a lathe, you could turn it outboard. Round a piece and use a gouge to make the groove. You could probably do a wheel up to 12" on some lathes without turning it outboard.

Sun, 09/16/2012 - 23:04

rigidheddlewea… (not verified)

Thanks everyone! We don't have a router and the bits are crazy expensive. This wheel is meant for minimal wood working skills and to be made inexpensively so that just about anyone should be able to afford it. Check the plans over at Ravelry for THE DODEC.  Make one or two or three and share them! :)

Sun, 09/16/2012 - 23:12

rigidheddlewea… (not verified)

The cutting board we used here is 14" in diameter.

Finished Length Unit
yards
Finished Width Unit
yards
Length Off Loom Unit
yards
Length on Loom Unit
yards
Number of Shafts
0
Project Status
Finishing
Sett Unit
epi
Width off Loom Unit
inches
Width on Loom Unit
inches