I just purchased a used Dorothy so that I can do sampling prior to going to the floor loom and was wondering if you warp it the same way you do a floor loom? Probably a stupid question but oh well.  lol 

Comments

SallyE (not verified)

Yes, you warp it the same way.  Enjoy your new loom!

 

kerstinfroberg

Keep in mind that sampling on a small (and/or table) loom will be somewhat different than weaving a "real" project. Here in Sweden the old rule of thumb is to widen the (sample) sett about 10% when going to widths of 90 cm (a short yard) or wider. The wider the warp, the harder it will be to beat.

jennybellairs

Thanks Kerstin for that tidbit.  I had never heard about changing the sett like that, but it makes sense.

Jenny in Charlevoix the Beautiful

kerstinfroberg

Of course, I should have been a bit more... specific? clear?

1. Swe rule of thumb: if going from "1" to "3" or more (read: if your "real" project is wider than 3x your sample), widen the sett. To what? well - sample... start at something like 10% wider

2. table loom vs floor loom: personally, I have never met a table loom on which I have been able to actually "beat". Have tried several approaces, such as clamps, holding w one hand while beating w the other, combination of both... Conclusion: table looms are great for colour sampling, maybe for structure sampling - BUT: if you are going to use a floor loom for the "project", you really need to sample/think about the differences in "natural beat" before starting on the Real Cloth

(I once did an ambitious project - a double-sided pick-up project in both structure and materials I was told "would not work". I sampled extensively - got results I wanted. Put on the full width project, some 4x the sample, I believe. The result is quite ok, but I just *could not* beat as would have been "best"... I can poke my fingers through it, which I could not on the sample(s). Pics some other day - it keeps the cold draught out of my studio)

Submitted by Jane Greer on