Hi, I just got a deal on a Newcomb Studio Art loom ($50.) I've finished cleaning it and getting it put together but I don't know how the pulley's go on to attach to the harness's and the treadles. Can anyone provide me with instructions/photos on how to do this? I would appreciate any help I can get. Thanks!
 

Comments

Michael White

Hi I will sent you photos tomorrow on the studio loom. You can see I picture of one here www.handweaver.us under looms. Leslie Johnson of Riverside Looms, MI [email protected] is the keeper of parts for Newcomb Looms.

Michael

rbratek (not verified)

Thanks Michael, I tried emailing her a month or so ago about my first loom that was in pieces but I never heard back from her. I'll try again though.

Michael White

I sent her an email this morning, I talked to Leslie on the phone last week. She is very good about calls and emails.I am thinking that the pulley tie up is the same, I am checking. I corrected the email address above.

Michael

rbratek (not verified)

With Michael and Leslie's photos and instructions I've been able to get the loom together and tied up. I had to use twine since it's all I had but it was just to practice anyway. I'll use braided cord when I get the new heddles and reed that I ordered. Here's a few photos:

 

Michael White

Robin, if you do not want to use the section beam do the following. Remove the bolts on the side of the sectional beams and turn them around so the dowels are faceing to the inside. You may have to sand the edges down depending on your boards.

michael

rbratek (not verified)

Thanks Michael, I never would have thought of that!

Your just full of good ideas : )

Robin

Submitted by Anonymous (not verified) on