Hi Weavers,

Regarding weaving a rag rug with printed cotton fabric for weft - can anyone suggest a suitable length for the individual (1 1/2" wide) weft strips that will wind around a rug shuttle? Should the strips be folded over or left "as is?"Has anyone else tried joining cotton fabric strips with no-sew heat bond tape (overlapping ends 2-3 inches) instead of sewing? I did this on a different rug project but have not washed it yet! Thanks for all your good advice!

Comments

Andrew Kieran (not verified)

I always just used to cut the sheets in a back and forth sort of way. So I'd make one wee cut at the end, rip down till I was about an inch from the edge, then cut again an inch up and repeat the process, turning a single bedsheet into one long strip. Then wind onto the shuttle until It could only just fit in the shed. Course you have slight lumpy bits where you reach the end, but I was never going for finesse with rag rugs. 

Benefit of this is you can get a bunch of old bedsheets and dye them different colours before cutting.

Oh, here's another thing, if you're tearing them, do it outdoors. I spent a day doing it indoors and gave myself a minor asthma attack and I'm not even asthmatic

Lenore

Thanks Andrew...great idea! Ripping sheets seems like a project my young grandchildren would love!

mneligh

I don't weave many rag rugs, but two local spinners cut the ends diagonally and use a glue stick that will wash out.  They also use the glue stick instead of pins in making quilts, with wonderful results.  The weave binds things together and there will be no bump where they join.

Lenore

Soluable glue sticks! Another great idea! Probably easier than the heat bond tape. Thanks so much!

johnos

 I've made rag rugs using t-shirts. You cut the bottom portion off at the armpits  leaving a tube. You fold this tube over so that the top portion is shy of the first edge by 3 -4". Then you cut paraell strips whatever width you desire. You cut through and stop so that you just cut through the whole top portion leaving a short part left uncut. Then you put the uncut part over you arm and finish cutting through on a diagonal with shears, when you're done you have one long strip.

 I've also sewn fabric into the same tube shape. Only one seam and cut the same way. Way easier than sewing all those shot strips together.

 If my bad discription is too hard to follow you can find videos on You Tube

Submitted by Lenore on