I am trying to determine the best epi for my project.  At this time I have only an 8 dents/inch reed and a 10 dents/inch reed.  I am looking at the reed chart in the Weaver's Companion and finding several set-ups that require for example: "2-3-3" as a threading sequence. 

My question is, does having different numbers of threads/dent make a difference in the results.  Is it better to fudge the number of epi to get a number that can be evenly distributed in the reed?  If so, which way is the better way to go - higher or lower?

 

On one of my first pieces using cotton warp and linen weft, my finished product had one light line the length of the piece.  As we observed it on the loom it was discovered that that light line was a spot where one dent had an extra thread. Because of that, I am a bit uncertain about using a sleying pattern where the numbers vary. 

 

What do others think?

Comments

TinaHilton (not verified)

Usually these lines will disappear when you wet finish the item.  I've never had a problem with having some dents with more threads than others.   I haven't had a problem so far, but most of mine has been with cotton or tencel when I've done this.   And of course you should sample to find out whether you'd get a better result from changing the epi or the sleying.

laurafry

So long as the compound sleying is consistent, it will look okay.  It's when there is one dent that is different that it will show up as a 'flaw'.

Whether you go denser or looser will depend on your judgement as to which is going to produce the best results for your textile.

Cheers,

Laura

tomrsey (not verified)

Thanks Laura and Tina.  I am going to make a scarf, so looser might be the way to go.  I am going to try taking the middle road and use a 25epi on a 10 dent reed using a 2-3 pattern. 

 

Thanks again for your help.

Submitted by Anonymous (not verified) on