I just pickded up a used Dorothy 4 shaft table loom.My normal loom is a 4 shaft countermarch loom and all my weaving drafts are for this type of loom.

My plan is to use the Dorothy loom for taking to guild meetings etc. and I have a project I want to put on the loom but I can't figure out how to do it. 

Here's my question:

Is there a way to weave a huck lace weave on a 4 shaft without using treadles or pick up sticks?  All my drafts show the need to use 6 treadles, 2 for plain weave.

 

 

Thanks all.

Comments

Sara von Tresckow

On a table loom, you'll use a "liftplan" that lifts the shaft combinations independently of treadles. For tabby, lift 1,3 and 2,4. For twill 1,2 - 2,3 - 3,4 - 4,1.

The hand operated loom is worked just like a jack loom with direct tieup.

EvaHall

I don't know the Dorothy, but I do have experience with a 4-shaft table loom, so I suppose it goes for the same. The fact is that you can do anything you can do on a countermarch loom with the same number of shafts, and you are not limited by the number of treadles. You change the position of the levers for each pick according to the tie-down drawing. Remember you can change any number of levers at the same time. I hope you can make sense of my explanation. Good luck!

yarncrazy

all- thank you. In addition to your response I also just found an old weaving today article by Laura fry on this. I'm on my way!

sandra.eberhar…

If you have weaving software, you can easily convert the tie up and treadling to a liftplan.  You can do this with a free, trial version if you use a print screen to save it.

Submitted by yarncrazy on