I am trying to make a Dr Who scarf, it has rows of stripes, the pattern says to make 3 separate warp chains and sley them one at a time. Anyone have any advice or a good method for stripes?

Comments

Sara von Tresckow

Break and tie - it is slow, but accurate and you have the Warp with color A, break, tie a thread of color B with overhand knot, warp with color B, break, tie a thread of color C, warp with color C. Repeat until correct color stripes and warp width are completed.

sally orgren

Can you post the issue of Handwoven and page this pattern came from? It sounds like the author was a front-to-back warper, and that may be what is tripping you up. 

I concur with Sara. Either wind one color at a time, or, once I see the directions, there may be a third alternative.

(I think your intuition is good about the tangling if you proceed as recommended.)

 

P.S. I am a Doctor Who fan too!

 

 

ldkocher

Hi, if I understand you, not a Dr. Who fan, it is a warp stripe?  Then when you put all of one color in one warp it proceeds faster.  Sley the first color through the reed.  Don't remove from the leash sticks but with the second color add another set of leash sticks on top and sley the second stripe.  Do not remove the second set of leash sticks and proceed with the third color.  You can ad as many leash sticks as you want.  Then when winding on there is minimal tangling.  I usually use this method when I am using up all of my leftovers.

Dan lee

Nov-Dec 2014 page 54

Thanks for the replies

sally orgren

Bummer! I can't find my issue. Hope one of my guild mates can help me out...

sally orgren

Bummer! I can't find my issue. Hope one of my guild mates can help me out...

Submitted by Dan lee on