I am nearly half way through a project and believe I will not have warped enough thread to complete it. I am certain that I followed the instructions carefully and measured the warp threads exactly as described. If I do come up short, it will be the second time this has happened. I use a warping board to wind my warp, I measure a piece of string carefully for the warp guide and add a few inches more to account for the knot to secure it to the peg. I try to warp my project thread loosely so I don't stretch it on the warping board. Could there be something about the way I am weaving that would cause this shortfall? I'm puzzled and discouraged. Any thoughts?

Comments

laurafry

Have you allowed for loom waste? Take up? I tend to round up and put a little extra on. If not needed for the project it can be used for sampling. If you haven't been able to find a teacher you might find Janet Dawson's class on Craftsy helpful. It's not expensive and even comes on sale fairly regularly. Cheers Laura

Sara von Tresckow

It is a good idea to know that every loom has a different amount of loom waste. It is entirely possible that the author of your project has a loom with very little waste. When you get to the end of your current warp, measure carefully how much you needed for the tieon and add it to what is left behind the last pick. That is the amount you will need to add to any project calculations. Possibly these instructions you are using are not even putting in the waste factor as it varies quite a bit.

General warp calculation is length of finished goods plus 10% for takeup and another 10% for shrinkage during wet finishing - add your waste calculation to that and then a few more inches for a fudge factor.

Ludmilla (not verified)

I add 27 inches for loom waste in addition to the take up that I expect. The take up is based on the weave structure. For example, rep weave has a lot more take up that other types of weaves. I also add extra for sampling and to make sure I will have enough warp.

There are a lot of good resources that tell you what take up you can expect for a weave type. You can look at "recipes" for a project and see what they used as well as general weaving resources.

 

Artistry

How's your beat? Is your beater heavy enough for what you're doing? Also is your brake attached correctly, if not you could have slippage every time you beat. Cathie
Submitted by cmsbcg on