I'm going to try my first double weave project. But, it calls for 20epi in a 10 dent reed. I don't have a 10, but I do have an 8 and a 12. Probably a dumb question, but can I convert like I normally would? 2-3 in the 8 dent or 1-2-2 in the 12 . . . I'd probably go with the 8. I can't think of it being a problem, but don't want to get too far into the project and find that I shouldn't have converted, but bought a new reed. Any help would be appreciated.

Comments

Sue in VT

Hi Marykayejn, I recently wove my first Doubleweave. I get neurotic when I'm trying new things, so I bought a 10 dent Reed. In the past, I always just substituted my other reeds when it called for a 10, and I'm sure you can do this on your Doubleweave project. Now that I've made a few blankets, I think I could have substituted. I was afraid of getting confused in distributing color stripes because I had to make sure all of one side would be on only two of the shafts and all the other side on the other two (for 4 shaft looms). So I don't think the substitution will matter but hopefully the experienced weavers will also weigh in!

marykayejn (not verified)

Thank you, Sue for the encouragement. I'm not sure about the stripe distribution either. And I really don't want to start though until I know for sure.......

ReedGuy

The reed is for sett, the warp order and threading is where you worry about the color and stripes. The reed just sets the spacing of the warp yarn. So are you actually worried about the width of the piece due to sett?

You can go ahead and use your reed sley pattern with your substitution as for any project. If you use the 8, then you don't have a dent with a singular warp, less abrassion.

marykayejn (not verified)

Thanks ReedGuy. That makes total sense. I figured it was a dumb question, just wanted to be sure. Wish me luck!
Submitted by Anonymous (not verified) on