I purchased a lovely 24" 8-shaft Ashford Table loom from a weaver last year.  It came fully assembled.  I am soon taking a workshop and I need to add more heddles to the loom, and am embarassed to admit that I cannot figure out how to access the harness frames to add the heddles.  The manual I have for the loom shows how to initially add heddles when assembling the loom, but this is a completely different scenario.   I've searched online and have not found anything yet.  Can anyone offer some advice?  Thank you so much!

Comments

arjill

It's basically the same. You loosen the screws on the sides of the castle and flip the castle on to its back. Mark the screws' positions with permanent marker on the texsolv shaft cords before unhooking the shafts from the cords. Have two knitting needles on hand with diameters slightly less than the holes in the shaft cords. Hook the knitting needles through the free shaft cords to keep them from slipping through the holes in the castle. Use a twist tie or thread and tie the heddles together that you are going to move through the holes in the heddles where they slip on to the top and bottom heddle bars. You can do this before you remove the shafts or after, just make sure to do it! Carefully pull one side off the shaft and remove the tied group of heddles and add them to the desired shaft making sure that the group of heddles is not twisted. Reverse the procedure and you are done. I have found it easier to remove every shaft until I get to the one I want rather than pulling it out and then trying to open a spot and sliding it back in, but that's just me.

Laurie Mrvos (not verified)

Thank you for this information.  I was surprised that Ashford didn't have anything on their web site about this, so I am very grateful to you for taking the time to pass this on!

 

 

Submitted by Anonymous (not verified) on