I am setting up my loom back to front to do a shadow weave gamp using 10/2 cotton. I have wound the warp and threaded the heddles and am now sleying the reed. But I am not confident that the tension on the wound warp is very good. Would it be a good  idea to roll out the warp to the front of the loom and then rewinde it (back through the reed and the heddles)? Has anyone done this successfully before? I am working on a rasmussen four-shaft table loom. Thanks!

Comments

sally orgren

You don't say how long the warp is, but under 6 yards, certainly. Are the lease sticks still in place? (If not, replace them.) You'll want to lash them to the back beam, to keep them from migrating toward the front of the loom.

Then I would chase everyone out of the room, and don't answer the phone!

At the front of the loom, divide the warp back into bouts 2-3" each, hang water bottles on the bouts at the top of the front beam. Slowly unwind until the bottles nearly touch the floor. Move the bottles back up to the top of the front beam, and repeat. You can put pots/buckets at the front of the loom, on the floor, to catch the bouts as they "puddle/pool". Don't touch them.

Once it is all unbeamed, do what ever you need to at the back of the loom to make sure all is well between the warp beam and the lease sticks. Unleash the lease sticks from the back beam, because you'll want to slide them toward the castle now for rebeaming.

Add the water bottles at the front of the loom to keep even tension on all the bouts and begin to rebeam. Adjust the bottles down when necessary.

Sometimes I have added a second set of lease sticks at the front of the loom. With the water bottles on the warp, the warp is under tension, and you can "treadle" them right in where you want them.

I think if you know the warp is beamed well, you will enjoy the weaving much more rather than worrying if you are going to hit a bad patch, and have to deal with it for yards and yards and worry if it is going to get worse.

Good luck — let us know how you come out.

Ann A

But I have already threaded the heddles so do I really need to keep the lease sticks? I like the idea of using the water bottles as weights. I hadn't thought of that.

sally orgren

With the heddles and reed sleyed, a short warp, and using the water bottles, that sounds like a lot of insurance!

Ann A

I will let you know how it goes. Thanks so much for your suggestions!

sally orgren

Adding the lease sticks back in is easy-peasy, assuming your pattern produces tabby. (Just treadle 1 + 3, insert a stick, then 2 & 4, insert the other stick. ;-) 

Submitted by Ann A on