I had several threads that were too tight and pulled; I cut and retied and the same threads are again too tight.  all heddles are correct and not twisted.  what can be wrong?

Comments

laurafry

Sounds as though the too tight threads were beamed at a tighter tension than the rest of the warp. If there aren't too many of them you could replace them by hanging repair ends off the back beam? Laura

sequel (not verified)

Are these threads twisting behind the lease sticks?  That will get them caught up and too tight.  Just stick your finger into the gap behind the lease stick and move the twist behind the back beam.  You will need to keep an eye on these pesky threads every time you advance the warp.

 

Submitted by rizzoratpig on