Adding more width to Undulating Twill Point 2/2 after beaming I now have my loom dressed and have begun sampling. Adding 1 more thread to the left side in shaft 4 worked perfectly - thanks to everyone who helped wiht that. This is a 6x repeat of 38 threads, for 228, plus the one extra, for 229. Unfortunately I have decided that this width will be too narrow for placemats after shrinkage, so I would like to add 1 more repeat of the pattern (I think?), on the right, since the pattern is already balanced on the left. (sett 16, 2 per dent in 8 dent reed). It's centered now ---------if I simply add 38 more to the right side (about 2+ inches), will it be a huge deal to be off center by 2 inches? I know it would be more correct to figure out how to continue the pattern for an inch or so on each side, but I'm not sure I'm confident enough to do that yet. Also --- is there any reason I cannot advance the warp at this point so that most of it is on the front beam, tie on my extra at the back, thread through reed only, and rebeam...then take out of reed, thread heddles, back in reed, and tie on at front with same tension? I realize I would have to unweave what I have already done in order to get good tension with the new threads being tied on. Thanks for any suggestions. I could continue, and just make small placemats, but I think I would be happier with them a bit wider. Cindy