Hi,

I have an Ideal. It's counterbalance. My problem is that when i create a plain weave shed, ! & 3 are fine, but when i depress 2 & 4, my shed is uneven on only one side of my warp. On the right side, the shed is perfect, with all threads down, on the left side for about 8 inches, many of the threads on shaft 3 seem to rise, which gives me trouble throwing the shuttle thru cleanly.

I think it has something to do with the horses (all my cords are the same length), the pulley cords are the same length, the lamms are even, the treadles are even. i've measured, fiddled and fussed, but still have the problem

any suggestions would be very apprerciated!

Thank you.

Mary

Comments

Dawn McCarthy

 Check to see if the texsolve heddles  are catching on the shaft in front or behind in that one area.  Start checking from the top of the loom down making sure none of the lam cords are tangled or crossed.

thebloominloom.blogspot.com

villageweaver (not verified)

Bloominloom,

thanks for the tips - i checked the texsolve and then started at the top - my shafts on the left were 1/2 inch higher and that caused all the trouble. it's amazing that we weavers don't hit the bottle....harder!

 

 

Alaire Rieffel (not verified)

 

This happened to me recently--the left wasn't shedding well, while the right was.  Turned out that one texsolv heddle on the left had been installed with its top on one harness and its bottom on an adjacent harness.  It was pretty subtle on an 8H loom and a big fuzzy yarn.  I didn't find it until I checked it for the 4th time by running my arm down between the harnesses.

edt (not verified)

Hi.

Sounds annoying. Could it be that you have left spare heddles on the "hanging" side, and they weigh those shafts down? I find that just a small number of heddles on the sides weigh more than one would think.

kerstinfroberg

This can also happen if the horses are not correctly placed.

Horses should be parallell to each other, but the left-side horses should hang "in opposite" to the right-side horses - like this (attempt at ascii art here): ----//----------\\---- . The "slant" direction is not important - but they should always be mirrored.

Kerstin in Sweden

 

Submitted by Anonymous (not verified) on