Good morning.

I inherited (for free) an Ahrens and Violette 16-shaft dobby loom along with a bunch of "stuff."  

I have been weaving for 6 years, but found an end-feed shuttle with the "stuff."  I have never used one before.

It has metal tips, so it may be a flyshuttle.  I do have pirns, too.

I can't figure out the tensioning system.  The shuttle is labeled "Ahrens and Violette" so it is pre-AVL.  There is a black screw/knob/something at one inside end and holes on the edges of the shuttle.  

Can someone tell me how this shuttle works?  I don't have photos yet, but can get them.

I did contact AVL to see what they have to say.

Thanks,

Allen

Comments

Bonnie Inouye (not verified)

How wide is your AVL loom? Does it have a flyshuttle mechanism? Look for the pieces if it is not already on the loom, as these are often removed for a while if not needed. The metal tips indicate that your shuttle was intended for a flyshuttle.

If you search for end feed weaving shuttle instructions online, you should find something. You wind the pirn from the large end gradually to the small end and not back and forth. A double-ended bobbin winder is best. Hold the yarn with some tension as you wind it.

There should be a tension device but your description is not enough for me to guess which model you have. A photo would help. But search first and see if you can find photos online to help you learn more about your shuttle.

Do you have a mechanical dobby loom (bars and pegs) or a computer-assisted dobby loom? Both are very good.

You are lucky! These looms are expensive.

Submitted by Anonymous (not verified) on