Trying to find some one with a similar loom Pics: http://backporchfiberworks.wordpress.com/2013/01/ need some info on warping the front beam as the fly shuttle set up seems to be in the way..Thanks

Comments

animalcrackers55 (not verified)

That is a great looking loom! I have a Newcombe Studio loom and a Reed Cambridge loom. Neither one has the flyer shuttle set up, but I know that the Cambridge sometimes came with one. In what way is the flyer shuttle set up getting in the way? Is it just awkward? I suppose that you could take it off if you wanted to. Anyway, I hope you can get her up and running soon.

sally orgren

That pipe bar that extends above/on top of the front beam shouldn't be a barrier to warping. (Barb Barnett in Plainfield, Iowa has several Deen looms with that piece mounted in the same way.) I believe it's a temple, not part of your shuttle system. If this is not what you are referring to, your photos don't show exactly what IS in the way (sorry!).

I questioned this summer if that pipe was mounted on the loom correctly, and I still need to search copies of the Deen manuals to check for sure. (Sorry, I was traveling this week and couldn't respond quickly.)

On the original looms I saw in Harlan, IA, that pipe bar was mounted even with the front beam, and I don't see a benefit of having the warp higher in front than in back. It is more common the other way around —the back beam is raised higher than the front beam to improve the shed on some looms.

FYI, the warp path should come up from sectional warp beam, up and over the back beam, threaded through the heddles, then reed, then over the top of that raised pipe and secure it to the front cloth beam directly, to a rod, or with an apron.

The fly shuttle boxes are beyond the reed to either side of the loom. The shuttle race is the flat wood piece at the bottom of the reed. The rope/cord that hangs down in front of the beater (or "lay" as the old Deen manuals refer to this) would never be in conflict with the warp path as described above.

I hope this helps. Do you weave a lot, or infrequently?

The original Deen manuals can be obtained from Janet Meany at www.weaversfriend.com. IMHO, they are not as helpful for specifics of warping as contemporary sources, which contain lots of images. 

Does this answer your question? I will try to post some photos at the original Deen thread...

weavebird1

See the bolts on the front beam they stick out oue about 1/2 inch, the hold the metal rope holders(ropes slide through these holders). And I do weave, on a union, a clement and others.  Unless the ladies I bought this loom from never wove anything wider then what was in the pic you posted of the four harness loom which is identical to mine except mine is two harness and has bolts protuding on the front beam. see pic below and you can see rope holders bolted to front beam.

weavebird1

you can see a larger clearer pic on the blog site in the pic of the side of the loom.

weavebird1

Kind of , its the  way the ropes for the shuttle are attached to the front beam. You couldn't weave only a small width runner with the bolts sticking out the front. seems very odd.

See pics for front beam.

Submitted by weavebird1 on