Aack!! I am winding a warp from a ball and a skein of nameless wool that I got in a swap.  The ball part went fine, but when I went to put the skein on my swift I discovered it has NO SKEIN TIES!  By snapping it I got it open fairly well and onto the swift, and by plucking I found an end which wound off surprisingly well -- until it ended.  It didn't snap as far as I could tell although I suppose it could have been a weak spot in the yarn.

I cannot find another end.  I've been over and over the skein (still on the swift) with a bright light trained on it, I've turned it inside out and back again, hoping to expose an end -- nothing.  What else can I try?

Comments

SallyE (not verified)

Get out your vacuum cleaner and put on the tube attachment.   Go over the whole thing with that until an end gets sucked into the tube.  

 

Michael White

think alike. This is what I told her to do over on Ravelry. Also just cut it and move on.

 

michael

Cynthia

The vacuum worked -- thanks so much.

Submitted by Cynthia on