I've just finished tying on a new warp for my 2013 tapestry diary and made photos of the process.  I've posted those at one of my blogs, Tapestry Share.

Of course, this is just my way to do this... many other ways are equally good.  

Tommye

Comments

Weavingholiday

Thanks for this, super helpful and really clear!

tommye scanlin

I hope it's helpful... at least it describes my own process.

 

SallyE (not verified)

I always understood the benefit of tying a new warp to the old warp, to be because the threading was complex.  That way you were able to "get it right" since you knew the old one was right and had already corrected any threading errors.  Or in the case of a draw loom, you were saving threading through 2 sets of shafts, and shafts that may be difficult to reach.

But with tapestry, it's a tabby threading on 2 shafts, or 4 if you are using a Moreman technique.  So is it faster to tie all those knots?

tommye scanlin

I use tie-on even with the plain weave for this loom and one or two other of my upright looms since it's easier to do than to totally rewarp the loom.  With everything in the upright position, I have to stand on a step stool to get to the top beam to place the warps, also have to stand while threading the heddles--or be reaching high, as I do it, very tiring on the shoulders.

So, for even a narrow warp that's on this Tissart loom (and one on my Ruthie loom--similar to the Fireside traditional tapestry loom), I prefer to tie onto the old warp.  And--yes, for me, it is much faster this way.

Tommye

jemwork (not verified)

thanks for the answer - I've not warped an upright loom & hadn't considered the points you make.
Submitted by tommye scanlin on