Beam w/slit Here is the beam with the slit. Does it go in the back of the loom?

 "I have what appears to be a CAMBRIDGE 4H 6T Counterbalance Loom in pieces and am trying to assemble it. I have gathered online photos to help me.

1st Question)  There are 2 roller beams I am assuming are the front breast beam and the back beam.  One of them has a slit in it the entire length, the other has LOTS of masking tape on it....

Which one goes in front where I'll sit and which is to the back? I am guessing the one with the slit goes in the back. Is that correct?"

Cloth Beam and TAPED Beam I think the taped beam and the cloth beam go in front?

Unassembled Cambridge Loom  Here is the unassembled loom. The sectional beam and the Beater bar are not in the photo. Harnesses assembly also not shown.

Thanks, Bonnie

Comments

loomroomcat (not verified)

beam with cloth goes in the front.

 

vanalpaca

OK, got that. There is a wooden beam with lots of masking tape does that also go in front. Then the beam with the slit would go in back?? I wanting to put it together more tonight and would hate to put it on backward.......

THANKS!

vanalpaca

I have a stick that attaches somewhere on the side to put on, need to find the screws for the legs of the beater bar assembly to the frame, I forgot to put on 4 really big washers and I'm thinking they probably went on the sectional beam and possibly the cloth beam....

I don't know what to do about the lamms. I know what my tie up should be for my project. The lamms are on strings hanging down from the shafts.

Anyone?

OK, I'm thinking it is coming apart tomorrow because I think that handle with the metal disk thingy goes between the cloth beam and the side of the frame..... so I might as well try to get those big washers put on too. I figured out how to put the lamms on the frame and I was all ready to tie them to the treadles, too....

endorph

could offer you some help but. . . Sounds like you are making some progress. Have you looked at any books that offer drawings of CB looms that might help you in identifying the parts - or even the Glimakra website that has tons of info on CB looms? THat might be another source of info for you

sequel (not verified)

Are there larger pictures of your loom someplace?  I really cannot see much in the postage stamp size photos in your initial post...

vanalpaca

Currently, I need to know where the giant 2 inch washers should go, like in between the wood and the sectional beam and /or the cloth beam and possibly between the cloth beam and the hand brake for it.

I also do not know how to attach the long wooden stick that is for the sectional beam brake. I did see a photo of where it goes, just don't know HOW to attach it.

I've made serious progress, but now have to tear it down again to get

PHOTO ABOVE SHOWS HAND BRAKE for Cloth Beam

Photo Above shows stick that is FOOT BRAKE for Sectional Beam

Photo Above shows the CAMBRIDGE 4 H Loom as far as I've gotten, but now it has to be torn down to install the hand brake and washers....

Photo above shows the area I have to install the hand and floor brakes.

 

Cat Brysch

the old wooden parts will tell you about where washers go...look for old worn places that size up with the washers. Usually washers are used between 2 moving parts and sometimes you might even have 2 washer together, if there's high activity, like on each ends of sectionals, where metal would meet wood.

sequel (not verified)

Have you checked here?  I though everybody knew about this resource.  The slit on the back beam is to hold a sectional warping aid.

Submitted by vanalpaca on