Hi, I am new to Weavolution, and weaving, I live in Scotland.
I am hoping for some advice, if anyone can spare the time. I have just bought a used 4 shaft floor loom. It has 8 horizontal jacks, 4 treadles and 4 lamms. It came in kit form and with no instructions for assembly. Its previous owner purchased it as a working loom, pre-loved 18 years ago , and never completely assembled it.
I realise that this is the worst scenario for purchasing a loom. But overall it is in good condition, apart from the inevitable rust on the metal parts. I appears to be homemade of pine, no warped pieces as far as I can tell, and has a 43 inch reed approx. 22 dent. Overall dimensions are 53"w x 48"d x 58"h. The shafts have Jones Textilaties Ltd. Blackburn, England printed on them, with metal heddles. ( I'm unable to find out very much about the company.) .
My question is this, is it a jack loom, or a countermarche ( which I thought had to have two sets of lamms i.e. 8 ), can a counterbalance loom have jacks? I have looked at many photos of looms, and of plans for looms ,but cannot find anything that resembles this one. I will try to post photos soon, but have not assembled the loom, only propped up the pieces together, to find out what goes where, before I clean and refinish it. It does not appear to have any pieces missing.............ie no extra holes for other pieces to be attached to.
Any comments would be appreciated , although I realise without photos its a hard ask.
Comments