I'm finally gaining ground on my new to me AVL. It's an older PDL. It has the cloth take up system with the horizontal weight, that slides up and down the track, at the outside of the front of the loom. I'm experiencing a twist as I bring the weight back up.

Would anyone kindly explain, once you have the weight on, and it is at the bottom, what the process is for taking the weight back up to allow more weaving and storage. I have looked at my manual (not enough info for me to proceed, and have spent time on AVL's site researching, not enough info).

I have read posts where you just roll the weight up, but when i do this, i'm finding my cords (weight and warp drum) criss crossing.

I'm sure it's something silly - but i can't wrap my pea brain around the correct process.

Thanks so much for any insight!

Mary

 

Comments

Dawn McCarthy

Mary, do you mean the cord is twisting?  Take off the wooden drum at the top of the loom - straighten out the cord and rewind it.  

Dawn

Mary Rios Lulich (not verified)

Hi Dawn, is this something that happens each time?

I did take the drum off and undid the cross.  But for some reason, i don't understand how to properly wind the two cords. I put the warp beam cord on the inside groove counterclockwise, so it comes up from the bottom pulley straight up. The weight cord routes straight up and goes clockwise.

When your weight is at the bottom how do  you just wind it back up? when i do this, the warp drum cord falls off the pulleys - seems hinky to me! 

thanks for any insight!

 

Dawn McCarthy

I used to have this system on my other AVL and I am trying to remember how I resolved it?  When the weight hit the bottom you should be able to rewind it back up again, so something is obviously "off".

Did you try lifting up the weight and locking it in the raised position and then tensioning the cord with your hand and winding back on?  I may have to defer to someone who still has this system as my PDL is a little older and has the hanging weight system.

kerstinfroberg

This phenomenon may be a cousin of my loosened spring (inside the back drum). As it was some time ago, I don't remember exactly - I *think* what happened when I wound the weight up is that tension went slack and therefore the weight-cord was uncontrolled.

What I did then was leave it at the bottom and manually wind the cord onto the cloth beam drum. This made the weight rise.

I am not near the loom right now, but I remember looking the other day: the warp beam cord is on the inner grove (but I did not notice the direction)

Submitted by Anonymous (not verified) on