I inheritated 112 ends of 10/2 cottolin approximately 7 yards long.  A pleasant deep green.  I refuse to take it off the warping board unless I'm putting it on a loom (too many warps in bags already) and I really want to get started on a particular project so this warp MUST get used.  Suggestions? Ideas? 

Comments

crosstownshuttler (not verified)

How about a mini friendship coverlet? Choose a threading and use as many tie-ups and/or treadlings as you want. Use one color or several colors for weft. Sew the sections together patchwork style or any design, really. Use as a table runner or center piece, a bread cloth, etc.

Let's see how many ideas we get here. This has great potential for imagination and exploration!

Carie

loomyladi (not verified)

That's a really cool idea.  I'll think on that one. 

It would also be fun to do a coverlet square swap.  Interested?  If we could get a dozen or so to weave a 12 or 14" square would probably be best to agree upon a warp fiber.  Hmmm.... the mind is thinking.

Finished square size 14" (12" pattern square with 1" plain weave on all 4 sides)

Cotton, Cottolin, or Rug Warp (one person could wind off yardage and ship off to others so that we all would use the same.  I happen to have a large qty of white cotton that I'd contribute.

Weft color, pattern, etc etc etc would be up to the weaver. 

r1mein54 (not verified)

You don`t say what size loom you would weave with, and instead of sewing a narrow strip together to make it wider you could cut the 7 yards to make a 224 end warp 3+ yards long.

loomyladi (not verified)

This project is destined for the 20" Purrington.  With the low loom waste on this loom I could easily do the shorter warp.  The warp is wound with only 1 cross so that would be a challenge.  Hmmmmm..... Thanks for the idea though.

sally orgren

Count me IN if you do it! Although it is tempting to consider carpet warp (due to low cost), I would nix that as a material for a project as nice as this. Cotton or cottolin would be better.

---

For your green 10/2 cottonlin-what sett are you considering? I am thinking if 24 epi, 112 warps only gets you 4.6" width. Do you have any other colors of cottolin that would go with it, to make a wider warp? If so, what about shadow weave? You'd need an equal amount of a light color to make a project 9" wide (summer scarf or table runner?). And then 2 colors for the alternating weft, but they would not have to be the same two colors or material, they could be in a related or complementary colorway.

Is there any way to "transfer" the cross to the other end of the warp? I am thinking the warp would need to be taken off the board, perhaps draped over something large (so each end dangles) with water weights at each end of the warp. Slide sticks into the cross end to "transfer" (or make) a second cross next to the first.

Then "walk" or pull those second set of sticks to the other end, hence the warp needs to be under tension on both sides for a smoother journey. I am not sure if I draped a 7 yard warp over the top my floor loom completely — that would be long enough for the ends to dangle, because I have a low castle loom. Could I hang it off my deck maybe? But the general idea is to create that second cross, so you can double the warp.

---

RE: 10/2 cottolin. I bought some at Convergence-Vancouver in peaches, pinks, light green, dark green, and natural from Louet Sales (60% cotton/40% linen in 3.5 oz cones @ 650 yds per cone). So if you are seeking more of the same material, let me know. I am not sure they sell it anymore, do they? (It was special buy-out at the time, 2002).

Sally

calebsb

Depending on the strength, it might make nice straps for a guitar or smaller stringed instrument.  It also could make an acceptable tape header for a rug, though narrower than the ideal 3" or so; always good to have a roll of that on hand. 

Submitted by Anonymous (not verified) on