Hi Everyone!
I am in a study group where we have been studying developing a block pattern then translating the block into an overshot draft.
I drafted a double pine cone pattern from my blocks. But I am having trouble calculating how to make a 6" square from my draft.
My notes follow.
I, too, have been weaving samples. Rectangle describes my sample. Not right! And the size, (are you sitting down), is 8-1/2" x 14", finished. Not anywhere near what I had planned. This was 11/2 cotton sett at 25 epi, 212 ends of pattern. Out of four samples I've done, I like the coverage of 8/2 Jaggerspun Main Line. But, this may change.
Could I please have some suggestions about:
* Sett for 20/2. (think i need to move to a smaller warp size, right?)
* Maximum number of ends for 20/2 so I can adjust my pattern.
*. What treading do I use? Currently I made my treading tromp as writ and treadled singly with no tie up for my 4 shafts.
* Comments from those of you who have used 10/2 and wove a 6" square (sett; epi and # of pattern ends); and
* Any other helpful suggestions.
Getting this to a 6" size is important to me. I want to learn how to make an overshot coverlet a specified size in the future. Many thanks,
I would appreciate your expertise in advising me. Thanks in advance.
**********************
Comments