I’m a textile design graduate from Ireland keen to start up my own craft/design business and took the opportunity to buy a second-hand Glimakra vertical countermarch loom a couple of years ago. After keeping it in storage for a while due to lack of space to set it up, earlier this year I began to put all the pieces together in my newly-built shed, like a giant jigsaw puzzle. Unfortunately I discovered that the loom had some woodworm and so I spent some time treating the pieces and varnishing to protect from the damp Irish winter in an unheated shed. Although the pieces did get a little damp, none of them appear to be warped badly and everything fitted together as it should. Now summer has come it’s all nicely dried out. Last week I finished threading up my first practise warp for a simple ‘goose-eye’ practise weave with 4 shafts (project from the Big Book of Weaving actually).
This week I apprehensively attempted the tie-up of the shafts, lamms and treadles. Because I had a feeling it would be challenging, I had done lots of research with the help of this site, Glimakra USA info pages and The Big Book of Weaving. When I remove the locking pin of the countermarch, unfortunately all the shafts fall down, until they rest on the sides of the loom frame and warp. The jacks fall into a horizontal position and the lower (long) lamms fall down to the bottom side bar of the loom.
I have read Joanne Hall’s info sheets on Glimakra USA and previous posts on this forum, but just cannot figure out what is going wrong. I’ve tried raising the upper lamms so that they slant upwards slightly, and tying up two extra treadles to add weight to the lower lamms but this doesn’t do anything at all as the lamms have already fallen as low as they can. As far as I can see, I’ve followed the tie-up instructions to the letter, it’s exasperating! Unfortunately I made the mistake of buying the loom unassembled (as the previous owner didn’t have the space for it,) and haven’t set up this type of loom before. The shafts and upper lamms do seem a little heavier than Joanne Hall has recommended on these pages previously, and heavier than new extra ones I have purchased from a UK Glimakra supplier, but as far as I’m aware they are the original Glimakra ones supplied with the loom and have been used by the previous owner. Surely the original supplier would not have supplied the loom with pieces that weren’t appropriate and a nightmare to balance?
The loom dates from about 1995 I believe, and weaves 150cm widths. The heddles are the standard recommended 11 inch length. When I read about how good Glimakra looms are I felt lucky and excited to have got this loom locally, as they aren’t common over here, but I don’t think I’d have bought it if I’d realised the set-up would be this difficult. I’ve already spent so much time and money on the loom, I can’t give up before I’ve even started weaving but at the moment it seems impossible! I simply cannot see how everything could balance when the locking pin is removed. Should the jacks really stay in a vertical position when the pin is removed?
I've attached an image showing the tie-up when viewed from the back of the loom, with the locking pin in place. As you can see, the upper lamms are slanting up slightly. I began with them parallel as advised in The Big Book of Weaving but re-adjusted them to this angle to see if it helped, but it hasn't made any difference.
If anybody has a similar loom or has seen this problem before, I'd really appreciate any help. Thank-you
Comments