I just bought an 8H Schacht table loom. The levers are numbered 1-8 with the #1 harness at the rear and the front harness connected to #8.

From the pictures I've seen, this might be backwards, but I can't tell for sure and the books I have on weaving don't say.

Does it make any difference? Is this right?

Comments

laurafry

It doesn't make any difference so long as *you* know which lever controls which shaft.  It may be possible to change it - check and see how difficult it would be to change things around?

cheers,

Laura

 

Broderie (not verified)

so long as *you* know which shaft is being raised, that's all that matters. Most European drafts are written corresponding to your levers, most North American drafts are written the opposite, with 1 being closest to the weaver.
Submitted by 1horsetown on