I would like information on warping boards. There are sooooo many types out there from 1/2 a yard on up. Which is better the board or the pegs? can some one help clear this up for me? And also is there any out there that my be preowned I could purchase on a cheaper level? thank you craftylady, in missour.

 

 

 

 

 

 

 

 

 

 

 

Comments

Joanne Hall

Check to see that the dowels are exactly perpendicular to the frame, that they are removeable, that they are not too long and it is also nice if the whole frame can be taken apart.  It is comfortable to wind on a frame that is about 1 yard across.  Less is too small and wider is harder to reach.

Joanne

Sara von Tresckow

What type of loom are you currently using? How long do you wish to make your warps? Do you have a place where you can hang the board on the wall for easier movement?

The answers to these questions will also help you decide. Don't be fooled by thinking that you are only going to make "little" projects - a warping board needs to be sturdy. 3/4" peg dowels would be the smallest that would resist bending when in use. If the dowels bend, every round gets smaller and your warp threads have uneven lengths. Also be sure that the spacing between the dowels is generous enough to fit your whole hand into or you'll find it awkward. Should you make your own or have one made, study how the ones offered commercially handle making the cross - if not done properly, this can cause great frustration.

debmcclintock

take a flat board, about 2 feet wide by 4 feet long, you can put a cabinet handle or leather strap at one end for handling board

buy some dowel rods, between 1" and 1 1/2" thickness

Trace out a warp path on the flat wide side of your board.

drill holes in your flat board that allow for a cross at each end  (3 holes in a line)  and some turning holes to take advantage of the board back and forth.  

You can take the dowels out, store the board flat and you are good to go

You can also drive nails into an outside building and wind there.  You need 3 nails for the cross and a turning nail.

Some folks use rods driven into the ground and walk the warp around 3 rods for the cross and have a turning rod.

You can consider these options to save $$$

laurafry

Like Joanne I prefer a warping board with removable pegs because that way I only need to set as many pegs as required for the length of my warp.  :)

You might find my You Tube video on how I wind a warp helpful.  

http://www.youtube.com/user/LauraAnnFry1

Scroll down - I have quite a few video clips about various aspects of weaving there.

cheers,

Laura

mneligh

Although I'm a sectional warper for most of my projects, a warping reel is my second choice.  Nonetheless, I've walked many a mile warping on posts in the ground, and it was fine.  I would stay away from clamped pegs, unless you make really small bundles of warp "hanks", as they tend to move as the tension increases with warp build-up.

For long narrow warps in nice weather fence posts work beautifully.  You can wind wider warps in sections this way.

Submitted by craftylady on