I am looking at the Weaving Today Elegant Placemats by Suzie Liles pattern.  I am new to weaving following Learning to Weave with Debbie Redding book, I have only done a basic baby blanket double woven on my Dorothy Leclerc 4 shaft loom which we built a 6 treadle stand for.  So now I would like to try to follow a pattern and looking at this pattern.the tie up has 7 treadles, but I only have 6.  I have seen this on many patterns for 4 shaft looms but dont understand how that works can somone please explain I'm sure I am missing something.  Thank you in advance Hollyann

Comments

laurafry

I was unable to find the draft so I can't help.  However, it is sometimes possible to set up a loom with a direct tie up and use two feet to treadle the lift combinations.  Can you give a link to the draft?

cheers,

Laura

kerstinfroberg

If it is the pattern from the free e-book, the treadling is divided to make 3 different patterns.

If you don't want/need to mix the three patterns in the same mat, you can just tie the treadles needed for your chosen pattern. If you then want to test the third pattern, change the tie-up (discard any of the tradles not used).

It is the pattern shown in the bottom of the picture that requires treadle 7 - but that pattern does not use treadles 3, 4 and 6.

Oops - typo - edited; next sentence is now correct:

(the first pattern doesn't use treadles 5, 6, 7; the second doesn't use 3, 4, 7)

Does that help?

Hollyann

Thank you both for your speedy response, sorry if this is a dumb queston.  Yes, it is the free e-book pattern, I am looking at the placemats on page 6.  Is this just something I can not do or is there something I need to change so that I can do it with 6 treadles?

endorph

7 treadles. If you look at the tie up diagrams there are 3 different options - huck, hcuk lace and huck boxes. Pick which option you want and tie up only the treadles that option calls for - Fo example - for HUCK - shaft 1 and 3 are tied to treadle one, shafts 2 and 4 are tied to treadle 2, shaft 1 is tied to treadle 3 and shaft 2 is tied to treadle 4. f you want huck lace leave treadles one and two as they are and tie up shaft 2 and 3 to treadle 3 and shaft 1 and 4 to treadle 4, If you want huck boxes leave treadle one and two the same and tie up shaft 2 and 3 to treadle 3 and shafts 1, 3 and 4 to treadle 4. You only need 4 treadles to do any one of the options. You can just leave treadles 5 and 6 alone. tina

kerstinfroberg

as seen in th photo.

Each pattern needs 4 threadles.

IF it is OK for you to weave one mat in each pattern (that is, not to mix the three patterns in one mat), you only need 4 threadles. You will have to change the tieup between patterns, though.

Here are the three patterns, separated. I put red lines through the treadles not used - that means the treadles can be eliminated (not tied) for the pattern in q:

The left tieup/treadling is for the top (in the picture) pattern; the middle one for the (surprise!) middle one; the right tieup/treadling is for the bottom mat in the picture.

IF you want to mix all patterns in one mat, your best bet would be to use a direct tieup and use both feet.

Have fun!

Hollyann

I see, yes I was thinking that was different parts of all one pattern!  So sorry, thank you sooooo much!  Shockingly I do understand the rest of the pattern, that part was just throwing me off...  Thanks again

endorph

of the learning curve. I have been lucky enough to have folks nearby who can explain stuff to me when I run into a question. Have fun weaving the placemats! And be sure to post photos on the project pages. . .

Hollyann

Looking forward to posting pics!  Thank you all for being so understanding. :-)

Havingfun

This is so very helpful. I've been restricted because I had the same confusion. Thanks so much for the explanation.
Submitted by Hollyann on