I have a  Wolf Loom and am weaving a set of towels in 8/2 cotton. I advance the warp and tighten as normal, but as I weave the first few picks, I'm losing the tension. I have to retighting a couple of times before it seems to "catch" then I don't have a problem until I have to advance the warp again. Does anyone know what the problem might be? Thanks in advance.

Comments

laurafry

Did you beam with tension?  if not there may be slack in the threads.  Otherwise check the brake system to make sure it is holding properly.

Like most everything about weaving, there may be several things that might be causing the problem.  Weaving is good exercise in problem solving!  :)

cheers,

Laura

Bonnie Inouye (not verified)

Make sure your warp is routed properly and wound in the right direction. Probably you have warped perfectly but it does not take much time to check this. Many, many weavers have made mistakes with the route of the warp!

Bonnie

Joanne Hall

is completely unfolded and tightened. 

Joanne

Jeane (not verified)

Thank you for your responses. I adjusted the brake and it seems to have helped. This is a new loom and I'm still testing the waters, making adjustments and trying to remember to read the instruction manual! All of your comments are very helpful.

alene

I have a baby wolf loom.  On my loom the brake release is very near the far right treadle.  When I started weaving on it, I would put pressure on the brake release when pushing the far right treadle down.  I almost never do this   anymore. I just needed to get used to the loom.

Alene

Submitted by Anonymous (not verified) on