I weave on an 8 shaft Schacht Mighty Wolf. When I create a shed, the bottom warp threads do not rest on the shuttle race, but float above it. I've tried adjusting the tension with no success. I had this same problem on my other floor loom. Can someone tell me what adjustments I need to make or what I might be doing wrong. Thanks in advance for any help!

Comments

SallyE (not verified)

I'm hoping a Wolf owner speaks up to help you. . . . .

I don't have a Wolf, but logically either your shafts are hanging too high or your beater is too low.   Can you adjust either of these?   On my Macomber there are chains, and you adjust them so that the warp rests just a little lower than the bottom of the reed.   That allows you do do a floating warp thread at the selvages that rides just a bit higher because it stretches straight from the back beam to the breast beam.  Hope this helps.

Joanne Hall

If your beater is not adjustable, then you have two options.  Since you have a jack loom, the usual way to solve this problem is to loosen the tension.  Jack looms provide a shuttle race on the beater so that it will support the looser bottom warp.  The other option is to put a metal bar on the top of each shaft.  That will add weight to the shaft so that you can tighten the tension more.  Macomber looms have heavier shafts than many other jack looms.

Joanne

gailc

You can raise the beater on wolf looms - there are two bolts/nuts on each side of the beater assembly and you can loosen them and raise or lower the beater.  At least that is possible on my older BW.

Jeane (not verified)

Thank you to everyone for your comments. Since my wolf is new and I'm still learning the adjustments, I had forgotten about the adjustable beater. Thank you to all that suggested it and especially to Gail for telling me exactly how to do it. I'm new to this forum, but anticipate using it a lot!

Submitted by Anonymous (not verified) on