I was going to weave a 20ft rug on my loom.  Then I decided that the weave I was doing was taking too long, so I only made it 7ft.  I cut the rug off, but I still have a ton of warp on the loom.  I could possibly make antoher 7ft rug.  Can I rewarp it?  I don't have the crosssticks in the warp, and I don't have a sectional warp beam.  Would it be a complete failure to attempt rewarping?

Help!

Comments

Erica

You can easily put the lease sticks back in by briefly tying on then treadling plain weave and placing the sticks back in. It helps to have another person or something to weight the treadles while you go to the back of the loom and place each stick.

Bonnie Inouye (not verified)

I think most weavers warp for more than one project because this is the practical approach. When I make scarves, I want enough warp for at least 4 scarves and possibly 6 or 7. Each will be quite different from the last one because I use a new treadling, new weft color, and sometimes change the tie-up too. Normally I weave one, then the next, etc, but rugs are thicker. When you need to cut one rug off the loom, secure the warp threads so the reed and heddles are still threaded. Often I weave some picks of a thin yarn, then weave two flat sticks, then a bit more yarn. I spread some school glue over the woven yarn and let it dry. Then I cut off the finished piece and its fringe, if any, leaving the glued cloth and sticks on the loom. The sticks are folded together and this is lashed to the bar of the apron. Then I resume weaving.

I would not want to waste the warp yarn after it is on the loom.

Bonnie

Kade1301

Sorry, I don't want to highjack this thread, but it is a related question: Often I would want to re-sly or re-thread the last meter of warp (just to try out how it would look that way). Meaning, the warp is no longer wound around the warp beam, but just hanging from the apron rod. As I warp generally back to front, there's only loops around the back apron rod - the threads are not fixed in place. Meaning it's extremely difficult to tie on again in front with equal tension. Any ideas?

Sara von Tresckow

No matter your warping method, waiting until the last meter of warp to change the threading is not such a good idea.

You can also experiment with different wefts, treadlings, pickup or many other variations at that point with much better results.

kerstinfroberg

Kade - the easy solution is to make the warp one meter (or two) longer from the beginning... ;-)

Submitted by Heather26 on