Normal 0 false false false MicrosoftInternetExplorer4

I was just given a Normalo 4 harness sinking shed loom. I'm looking for any information on the company and/or pictures; it was disassembled when I got it so I want to make sure I have put it together correctly.

 

Comments

sequel (not verified)

I have a Normalo in storage, and have pictures of it, and a few pictures of another.  The "jacks" are above the shafts, and are operated by treadles below the warp and springs above, in the castle. The warp is pulled down by the treadles, expanding the springs, when the treadle is released, the springs pull the warp back up to the resting position.

With this loom, you should avoid adding any weight to the shafts and tie-up.  Use cords instead of chains, use string heddles, etc.

If your springs are rusted, well, they look a lot like screen door springs and you could probably get some new ones at the hardware store... probably a real hardware store, not a big box retailer.

Send me a private message and I will try to locate the photos for you.  May take a while for my husband to scan them though!

 

 

JGilbert

I have a Normalo-12 shaft loom. I contacted the mfgr in Finland who recommended using bungee -type cord. The recommended diameter was about 1/8". The recommended length was about 22 inches. I crafted my own set of springs, making custom-bungees. I twisted the end hooks using a lightweight wire which I purchased from my local Home Depot. The bungee cord came from a nearby Army-Navy surplus store. The same Army-Navy store also sells metal springs, which can be added to fine tune the tension. There is a correct tension that you have to create to keep the spring arms up and balanced against the tension needed to depress the shaft using the foot pedal. You find that tension through trial and error. Once you engineer the first spring, all others should be a duplicate. I can send you photos of my finished loom if you contact me at [email protected]

Submitted by K A M on