I suppose this might be a question for spinners who own their own fiber animals. I've been weaving for about 4 years now and I'm taking my first spinning class in July! (I'm very excited) we will be taking a raw fleece and washing, dyeing, spinning and plying it. Here's my question. I've done a bit of reading on wool and how much you get per sheep. from what i've read, wool is measured in multiple ways but what I'm curious about is the spinning count. Obviously it's different for different breeds. So let's say that a sheep produces wool that has a spinning count of 56-58s. From my understanding, that means you can spin 56 hanks (560 yards long) from one pound of yarn. This has me so confused because I can't see how you can possibly get that much yarn from a single pound of fiber. It would be close to 32,000 yards per pound! That's like the size of...I don't know. 60/2 silk or smaller? So is this mesurement for spinning count is assuming you're spinning tiny yarn? I've tried to look all over the Internet to find info about this and haven't found any. I'm just curious how much yarn I'll get out of the class and if I buy a fleece in the future at some point. Another question, does anyone sell thei handspun yarn? And if so, about how much an ounce do you get for it?

Comments

Claudia Segal (not verified)

These are all good questions.  I've only been spinning for about 2 years and I did buy 3 fleeces and after it was washed and carded, we had 5 lbs from one and 8 lbs from the other two.  The 5 lb fleece produced about 2500 yards of yarn.  Some was 3-ply sport weight and some was 2-ply fingering weight.

It depends on many factors.  How much you have once it's cleaned and carded, how you spin, how you ply, etc.  Just like weaving, there's a learning curve.

Claudia

Sara von Tresckow

Those counts are theoretical and based on industry standards.

Most handspinners get to laceweight knitting yarn and not much beyond. The fineness of a fleece only partially determines the resulting yarn. Just start by getting a good clean medium staple medium crimp medium fine fleece - practice - and see how it goes from there.

I'm always a bit curious what people think when seeking 14 micron fiber - it won't really make much difference in handspun, that ultra fine fiber only shows its stuff when machine spun to worsted yarn for men's suiting.

As with anything, spinning is an acquired skill and your first yarn will most likely bf the "designer" variety - keep all of it - makes a wonderful accent yarn for weaving projects.

When selling yarn, you must first determine that it is of sufficient quality to actually sell - and then determine what the local market will bear. Beginner yarn is usually not that sought after.

kerstinfroberg

On the other hand - a fine yarn spun from a coarse fibre will feel different from a fine yarn (the sam grist) spun from a fine fibre. (It will also look different... and will take a different amount of wear)

That said, a good medium wool can be spun into very different yarns, and so will go a long way while learning. And practicing/experimenting is what makes a good spinner!

Have fun!

Badfaerie (not verified)

The s count is based on the extreme, the finest single that can possibly be spun from that fiber. If I remember correctly, it's based on the micron count. I don't pay much attention to the s count except as a guide to how course or fine a commercial top is going to be if there isn't also a micron count. So I know an 80s merino is going to be in the 18 micron range and pretty fine, 150s is cashmere area, 40s is going to be coarser and probably not suitable for next to skin yarn.

No one is going to expect any hand spinner to get the yardage indicated by the s count. As a spinner, experience will teach you what yardage you can expect out of a particular fleece depending of the yarn weight you go for. I also studied commercial yarn labels to see the yardage/weight commercial yarns of the same fiber types were. So now I know that a fingering/sock weight will be 100-110 yards per oz, a good aran weight will be about 75 yds/oz, as I spin them.

Don't let the numbers and nomiclature scare you, it comes together and makes sense as you learn.

mrdubyah (not verified)

The amount of yarn you'll get does depend on the grist (diameter) that you choose to spin, but it will also be affected by the spinning technique you apply.  Woolen spun yarns are lightweight, fluffy and full of air, so you get a lot more yardage per pound than if you spin worsted which produces a denser, and therefore heavier, yarn.  Yarns spun semi-worsted/semi-woolen will fall somewhere in between.  The wide range of options available is one of the reasons to spin your own yarn.

Michael White

Speaking of silk: One cocoon can give you one denier of filament which is 9,000 metres or 9,750 yards just over 5 miles, weighting 1/28 of a ounce.

Michael

Karren K. Brito

I'm always a bit curious what people think when seeking 14 micron fiber - it won't really make much difference in handspun, that ultra fine fiber only shows its stuff when machine spun to worsted yarn for men's suiting.

At Stringtopia it was clear to me that some of the attraction to mixtures of silk/cashmere was the sensousness of the fiber passing thru the spinner's fingers.  These people were dedicated spinners, both spindle (that's Abby's fault) and wheel spinners.  They spin because they like the experience and beautiful colors and well prepared batts of fine fibers all contribute.  Spinning today is a choice and the reasons for doing it are very different than from a century ago. 

It seemed to me that they would buy a 2 oz. braid of silk/chashmere fibers, spin it into fine lace yarn, then knit a complete gossamere triangle lace shawls from it.  And have a lot of fun doing it!

loomroomcat (not verified)

I sell quite a lot of handspun each year.  I charge $4.50 per ounce for a 2 ply of yarn from handpainted rovings.  Anything exotic (ie. alpaca, silk, bamboo) I charge $5.50 per ounce.  Price depends a great deal on where you are selling also.  I am in economically challenged Michigan.

Submitted by Anonymous (not verified) on