Ok this is another question, I've just discovered treading on my weave-maker, and I just manged to understand it and so excited... Ove the past 2 years of weaving the tutor advice to not bother with treading, as we were using jack looms, But i've just found a whole new world of designs and complex weaves using treading.... So do I need to apply the trading plan or not ? I've tried the designs without the treading and dosnt work. I'll be branching out now with very little support in my final year of University, And just found my own feet within weaving, Now this thing with treading it now bambozzled me? Use or not Use....

My last post was on circles, Now i'am on track, using the treading in the weave it become less complex.

 

Comments

lkautio (not verified)

I am not sure what your tutor was having you do, but most people using a loom with more than two shafts have some sort of treadling plan, even if it is very simple.  Look at the drafts which have been posted here.  Almost all include a threading plan, treadling plan, and often a tie-up in the corner.  The tie-up tells you which shafts always rise (or lower) together.  The treadling tells you in which order those combinations are used.  Another format is the liftplan (which might be what you are referring to).  It is a combination of the tie-up and treadling.  Each line of the treadling then shows which shafts are used (no tie-up). If you have a loom with treadles you may end up with more different shed combinations that you have treadles if you are not careful when designing in the liftplan.  Lift plans are often shown for 4S looms, table looms, and dobby looms, but can be used with care on multishaft (more than 4) treadle looms.  They do open up a world of possibilities.

Laurie Autio

 

Bonnie Inouye (not verified)

Books can be very helpful when you are learning about weaving drafts and weave structures.

We are fortunate to have quite a few good weaving books available now for downloading, mostly through www.handweaving.net.

If you are struggling with WeaveMaker, contact Eleanor Best. She produced a CD with lots of information and ideas about this program.

 

Submitted by Anonymous (not verified) on