I hope someone can help! 

I am using 10/2 mercerized cotton warp and weft for the first time (I usually use wool).  The draft and yarns came with a kit for a scarf.  With each advancement  of my warp, the wefts of one of my blocks pulls apart over the apron.  The weave is looser here - not a plain or twill - I'm too new at this to know if there is a specific style associated.  Anyway, what is the trick to having a taut warp but not disturbing a loose weave as it moves over the apron?

 

Thanks,

Kelly

Comments

Kelly M. Wade (not verified)

I really didn't realize I'd get 32 views and not a single reply. Hmmmm. How disappointing. Hope this is only a trend on this site. See ya!

Karren K. Brito

I found the same question elsewhere and posted a reply there.

laurafry

Not a stupid question, but the answer may be complex. What epi/ppi are you using for your cloth? Generally such slippage means the cloth is too loose but since you are using a kit, one assumes the set is correct. Since one assumes the set is correct, the answer is not obvious. Cheers, Laura

Joanne Hall

It is hard to answer this question, as there is just not enough information to determine if the problem is in the sett being too open, the beat being too light or if the loom is too small or the breast beam to sharp. Any of those could be the problem. Joanne

kerstinfroberg

This sometimes happen to me, too, but usually not on the breast beam. I use warp sticks for about one turn on the cloth beam, and on open weaves I can often see the edges of the warp sticks (usually only for as long as the cloth rolls directly on the sticks).

When cut off, if I leave the cloth alone for a day or so, most of the marks are gone, or nearly gone.  If I deem them "too visible", I try to work the piece on the bias - stretching this way and that for a while. The rest of the marks usually go away in the wet finishing.

Should I think that some marks are too big (before wet finishing), I try to move the errant picks with a blunt needle - carefully, as it is quite easy to introduce new marks this way..

On the whole, I find that most marks, be they reed marks or beating marks, disappear in the wet finishing.

Good luck!

Submitted by Anonymous (not verified) on